Variegate, Inc. Stamping Presses and Related Equipment   Magnetic Die Clamping and Magnetic Mold Clamping by EAS

Electro-Permanent Magnet Die Clamping

These magnetic modules are designed expressly for mold clamping on metal stamping press die clamping. They are provided with a specific magnetic layout and neutral areas for scrap removal.

The system includes a proximity switch to ensure the die is within 0.006" of the bolster or ram surface before clamping is allowed. The system uses as little as 1.5" (38 mm) of shut height for the ram plate and 2.17" (55 mm) of shut height for the bolster plate. The additional thickness provides room for die lifters. For the force feedback system both plates must be 2.17" (55 mm) thick. The magnetic flux generated penetrates the die for 1.18 inches (30 mm) at a controlled depth, enabling it to hold it in safely without interfering with parts inside the die. The magnetic poles hold 440 to 5,620 pounds (2.2 to 25 kN) depending on the type used. The magnetic die clamping system cannot overheat and is not affected by electrical interruption.

Advantages:

Fail Safe:

AP & T North America Pressroom Automation  Press Servo Transfers, Blank Destackers, Speed Feeders, Tandem Line Automation, Tooling, Integration ...

Quick Die Change from PaceSetter Systems Bolster Extensions, Die Lifters, Hydraulic Clamps, Quarter Turn Clamps, ...

Magnetic Die Clamping and Magnetic Mold Clamping by EAS Electro-Permanent Magnet Die Clamping and Magnetic Mould Clamping

Request a Quote - Click Here

E-Mail: Click Here to E-Mail Variegate, Inc.

Voice: (256) 830-6679

Variegate, Inc. Since 1992 - 111 Grayfox Trail Huntsville, AL 35806

Copyright Variegate, Inc. 2000-2017

Variegate, Inc.'s Main Menu